![]() ![]() ![]() ![]() The configuration created may be changed later on in the menu: Run > Run Configurations.īy launching a file, the console should be brough forward with the output of the code (if you had some exception raised, clicking on it would bring you to the code in the stack-trace).Īfter the first run, using Ctrl+F11, the last file should be re-run. You have that has the interpreter you want to use for the run or create a PyDev project as 'external_projects' and bind those runs to it). It'll still ask for a project to resolve the PYTHONPATH and interpreter to be used (you can probably just use any project So, a file may be dragged from the filesystem intoĮclipse and later, with the editor open F9 may be pressed to run the file. Tip: you may want to pre-select the test to be run in the editor (with Ctrl+Shift+Up or Ctrl+Shift+Down) so that Ctrl+F9 will have that test pre-selected to run.Įxternal files may be launched, but an associated project must be available.Note: if you were using unit-tests, you could use: Ctrl+F9 to run the unit-tests from the module (and even selecting which tests should be run - and if Shift is pressed it's launched in debug mode).Go to the menu: Alt + R + S + The number of the Run you wish (It can be Python, Jython, unit-test, etc).Use a shortcut: F9 to run the open editor based on the project configuration where the module is contained (or for debug mode Shift+F9).
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |